The support engine light will flip on at regular intervals when your motor vehicle desires program maintenance. Just after the upkeep is completed you certainly will will need to manually reset the light to turn it off. This is often a straightforward adjustment that may only get several moments. Others Are Reading through Methods to Reset the "Service Engine Soon" within a Chevy Learn how to Reset a Chevy S10 Computer Things You'll Have to have OBD II scanner tool Ignition key Show More Instructions 1
Look for the OBD II port located near the emergency brake on the lower dashboard. The OBD II port will be the receptive end for the connector on the OBD II scanner tool. Examine the connector end of the tool and the receptive port to make sure you have the correct port. Plug the OBD II scanner tool into the port.
2
Close the doors, roll up the windows and flip on the OBD II scanner tool. Put the key into the ignition and turn it to "on," but take care not to start the engine. Turning the car on will start the electrical system which will power the OBD II scanner tool and allow it to do its job. The engine requires to remain off for the scanner to work.
3
Wait for the screen on the scanner to stop flashing. The service engine light will have turned off. Flip the key in the ignition to "off" and unplug the scanner.
4
Restart the engine and verify that the service engine light is still off on the instrument panel. Flip off the car.
No comments:
Post a Comment